Advertisement

How to make a lace bracelet

Dainty little bracelets can be a beautiful way to add some sparkle to an outfit, but sometimes you need a bolder look. That's where this lace bracelet comes in. This wide piece of jewellery gives a cuff or bangle type of look without the weight and it customized to the exact size needed so you don't have to worry about it slipping off your wrist.
Not a fan of pink? Although the pink velvet ribbon pairs well with the lace for a soft and romantic look, you can add faux leather strapping or cord for a more rustic accessory.
Advertisement
Materials
- Lace
- Scissors
- Chain
- Jewelry clasp
- Needle-nose pliers
- Hot glue gun
- Tweezers
- Gems
- Velvet ribbon
Instructions
1. Wrap the lace around your wrist to check for size. Cut off this amount with scissors.
2. Trim the edges of the lace if they are uneven.
3. Open the end ring on the chain with needle-nose pliers and tweezers.
4. Place the end ring through the end of the lace and pinch it closed once it is in place using needle-nose pliers.
5. Repeat steps 3 and 4 on the other end of the lace, this time attaching the jewelry clasp.
6. Add small dots of hot glue to the lace on the middle of the bracelet and press gems into the glue using tweezers.
7. Cut off a section of velvet ribbon with scissors.
8. Wrap the velvet ribbon around one edge of the lace and secure using hot glue.
Advertisement
9. Repeat steps 7 and 8 for the other end of the lace.
Resources
Share on Facebook

Not only is it inexpensive (especially if you own a chainsaw and a couple of trees), it is a unique way to bring the outdoors into your indoor decor.
September 20   ·  
Advertisement
Do you need a new pinboard? This DIY version is so pretty and takes very little time to make.
September 20   ·  
You absolutely need to check out these ideas before you throw away your old headboard!
September 19   ·  
 
Recommended
Advertisement
Advertisement